filling pinblock/"fitting" pins

[Marcel Carey]

Or you could shim with emery cloth and still use #5 pins...It takes
time, but it works.

Marcel Carey, RPT
Sherbrooke, QC

> -----Original Message-----
> From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org]On
> Behalf Of David Renaud
> Sent: 10 fevrier, 2004 21:20
> To: pianotech@ptg.org
> Subject: filling pinblock/"fitting" pins
>
>
> Assistant destrung upright & kept one sample pin for
> me, #3. I tested a #5 on one note, felt really good.
>
>    Happily stringing, everything feels great.
> Do about 20 unison's, nice even tight feel.
> suddenly the holes are bigger...allot bigger.
> I can push the #5 in and out with my fingers.
>
>    Happens there was more then one size used when
> it was strung years ago....oops. assumptions strike
> again.
>
>    Considering the following......
> swab holes with West System epoxy, or with
> Webb Phillips Wood Rebuilder, put in undersize
> pins while filler cures....remove undersize pin
> and continue stringing. I know someone is going
> to say replace the block....not an option this time
> unless I eat it..$
>
>    So comments on these options appreciated.
>
> 1) Above procedure with West System epoxy.
> 2) Above procedure with same epoxy mixed with
>    a little hard rock maple dust...have a can
>    saved from grinding pinblocks.
> 3) Webb Philip's product....wood rebuilder.
> 4) plug it up and re-drill.
> 5) And yes, for those that may say, "eat it"
>    do the block and learn your lesson. Go
>    ahead, I own a custom fit flame suit.
>
>                         Cheers to the Esteemed list
>                         Dave Renaud
>                         RPT
>                         Canada
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> ____________________________________________________________
> __________
> Post your free ad now! http://personals.yahoo.ca
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives