Hello Kent, I have seen and worked on several Style 2's and the ones I have seen have had the tuning pins vertically oriented as John H. suggests. However, I do believe there is another kind with tilted pins as suggested in another post. The very first thing I would do, before any other techniques is employed, is to place all three feet (or only two if that is all that is available), upon the pedals, push downward as intensely as one could without damaging anything and try simultaneously to extract the action. The downward sagging of the keybed with enough pressure may let the action pass. Regards, Robin Hufford Kent Swafford wrote: > I would like to see these. > > I seem to remember seeing a cross-section drawing of a Style 2, but > can't locate it this evening. If anybody recalls that drawing and where > it might be found, I would appreciate seeing it again in order to > understand more about how these were constructed. > > Kent > > On Feb 28, 2004, at 8:02 PM, John Hartman wrote: > > > I have some photos of a pin block replacement I did on ones of these > > quite a few years a go. If any one is interest I will place the few > > photos I have in digital form on my web site. I have a more complete > > set of these I have shown at some of my classes. > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC