Hello Stephen, I have a good variety of pinblock scraps lying around my shop. Delignit pinblock and bridge capping material (12 mm thick), quarter-sawn 5-ply and flat-sawn multi-lam. Would you want samples of each? How thick? Four-inches by how long? Sent me an exact address. I also have some hybrid - standard pinblock that is capped with Delignit. Is that of any use to you? So, curious minds want to know though...... wazzup? Happy to help. Terry Farrell www.farrellpiano.com ----- Original Message ----- From: "Stephen Birkett" <sbirkett@real.uwaterloo.ca> To: "Pianotech" <pianotech@ptg.org> Sent: Wednesday, October 06, 2004 4:54 PM Subject: pinblock material > I need a small sample of delignit for an experimental setup. I wonder > if one of you kind souls who installs pinblocks might have an offcut > lying around in the shop that you wouldn't mind passing on to me. A > piece with about 4" on at least one dimension would be adequate for > the intended use. An offcut of some non-delignit pinblock material > would also be nice to have for testing. > > Stephen > -- > Dr Stephen Birkett > Associate Professor > Department of Systems Design Engineering > University of Waterloo > Waterloo, Ontario > Canada N2L 3G1 > > E3 Room 3158 > tel: 519-888-4567 Ext. 3792 > fax: 519-746-4791 > PianoTech Lab Room E3-3160 Ext. 7115 > mailto: sbirkett[at]real.uwaterloo.ca > http://real.uwaterloo.ca/~sbirkett > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC