Terry, It's simply that the "Face" has a tighter radius than the "Spine". Is that not adequate evidence ? Thump --- Terry <terry@farrellpiano.com> wrote: > You still don't know for sure because you don't know > how the rib was originally shaped. I assume you mean > the "face" to be the surface glued to the panel and > the spine is the opposite surface. What if the > "face" was straight and the "spine" was contoured > (feathered) originally. Dry down a panel and glue on > the ribs. Let the board develop its compression > crowning and now you have a curved straight "spine" > and a curved "face". > > Terry Farrell > > > Terry asked: " How can you = > determine that? If the rib is curved, could it > still not be from panel = > compression? You may well be correct, but I just > don't see how one could = > be so sure. > > Terry, > It's simple. Use a straight edge. If the rib > "face" is curved and the "spine" is straight, then > the rib has a machined "crown". With an olde piano, > the "spine" may be curved the other way. Still a > machined-in crown.<G> > Joe Garrett, R.P.T. > Captain, Tool Police > Squares R I __________________________________ Do you Yahoo!? Yahoo! Mail - Find what you need with new enhanced search. http://info.mail.yahoo.com/mail_250
This PTG archive page provided courtesy of Moy Piano Service, LLC