This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Brad asked: "Would you use pin driving fluid, or spar varnish on every = job with new block and stringing? What about Bolduc block, drilled with cobalt .257 bit (as recommended by Pianotek). Does every new block require pin driving fluid?" Thanks Brad, I was taught to use the stuff, by Del. However, I don't think he = espouses it's use, today. (correct me, if I'm wrong, Del.<G>) There are many Rebuilders that do not use it, and get good results. IMO, = it makes the pin block a bit more forgiving of drilling/density = differences. SO....I strongly urge the use of Pin Driving Fluid. I've = tried NOT using it and was not satisfied with the results. YMMV. Best Regards, Joe Garrett, R.P.T. Captain, Tool Police Squares R I ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/16/6d/1d/6c/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC