This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Dale, A picture would be helpful in visualizing this... David I. Original message From: Erwinspiano@aol.com To: pianotech@ptg.org Received: 9/6/2005 3:45:03 AM Subject: Re: Hammer sanding ,machne Carl -- David I. After using many forms of electric sanding devices I don't see how I = can take a un -shaped set of new hammers & effeciently design a hammer= shape with this tool. Perhaps that's not what it's use is for. I curre= ntly use a small sand cat belt sander & more recently a Makita hand h= eld belt sander with a 1 inch wide by 18" belt. It's a bit awkward & do= nt' recommend it for anything but gang filing when shaping new hammers= held in a gang clampm in a vise with plenty of clearance. I do however use the makita on hung hammers when trying to do huge am= ounts of shape redesign & felt removal but I just do the rough work wi= th the tools & finish with 80 thru 400 grit paper. Short of that the fo= redom works bset for this particular job as one can focus all the atten= tion to shape on one side then the other & lastly the top. my guess is that Joe's tool is extremely effective for the applicatio= ns it was designed for such as upright actions.... Right Joe? Or splain= it further to dense heads like me. Maybe I need one Just my 2 cents. Dale Carl, so it goes back and forth...how do you get a particular shape? I'm th= ink of a worn hammer where I want to bring the shoulders down and not t= he top. How is that accomplished? David I. David, just push the sander fore and aft to sand only on side of the ha= mmer. Press down to sand the top. Rotate the sander and push side to = side to clear waste felt. You need to do this since if you don't the f= elt will clog the paper and stop working. Fifty or sixty grit is good = for speedily removing felt. For smaller hammers I usually squeeze the = blades with thumb and index finger to sand only the sides. Remember th= at this tool is basically roughing it in. As Nick Gravagne said in a c= lass "We're just shoveling dirt". Final shaping and squaring is done u= sing standard paddles or your favorite procedure. Carl Meyer PTG assoc Santa Clara, Ca. ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/03/26/66/c7/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC