Impact LEVERS, was: Impact hammers

[Michael Gamble]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
Hello Terry et al

Tuning Hammer - really degenerated from idiosyncratic nomenclature in use
since the year dot. Was originally 'T' hammer (for reasons obvious) then
just sort of got included in the general run of name calling to "tuning
hammer" - a name I don't use myself. With me it's either a 'T' hammer (for
grands that lay down flat) or a lever (for upright verticals which stand
up-right) :-)

Regards

Michael G.(UK)

 

  _____  

From: Farrell [mailto:mfarrel2@tampabay.rr.com] 
Sent: 18 September 2005 16:12
To: Pianotech
Subject: Re: Impact LEVERS, was: Impact hammers

 

Hey Joe - You don't need to re-set an impact lever on a pin for any reason.
You simply put it on the pin in a favorable position much like you do with a
traditional lever. If you find yourself removing and re-setting the impact
lever on tuning pins, I would suggest that you simply haven't figured out
where to position it in the first place!  :-)

 

What is your "knob hammer"? I presume this is some type of tuning LEVER? Is
it some type of impact lever or a traditional lever? Assuming it is some
type of traditional lever, please be aware that no one that I know of is
trying to argue that an impact lever is "better" than a traditional lever.
There are advantages and disadvantages to each and some will always prefer
one over the other. Both can be used, with training, to produce a
well-tuned, stable piano.

 

The one thing that I do say is that if you have been using a traditional
lever and have arm and/or shoulder pain related to tight-pinned pianos, an
impact lever can offer you relief from the pain and let your body heal.

 

BTW: Where on earth did the term tuning hammer ever come from? These levers
that we all use to tune pianos with look a lot more to me like tuning
LEVERS!

 

Terry Farrell

----- Original Message ----- 

 

That is exactly why I quit using the impact tool. It was so slow in that one
needed to re-set the hammer on the pin to get the impact at the correct spot
for fine adjustments. With my knob hammer it is only necessary to loosen the
grip on the pin a tad to get more movement.

Usually one just bumps the knob to relax the pin If you have not raised the
pitch too far. And if too far a click down and right back up.

Wierd but it seems that once the pin has been moved up a click and down a
click, one can make smaller clicks of the pin back up again.

Joe Goss RPT

----- Original Message ----- 

 

    Clue me in on impact hammers.  I used one on trial and was frustrated,
finding it difficult to make fine back-and-forth movements in the pins.
Moving in one direction was fine, but to go back the other way I had to
first take up the slack in the head to reverse direction.  Am I to
understand that one doesn't make tiny, slow pull changes but instead uses
the impact feature exclusively?  Otherwise it seemed that the wide movement
of the handle was cumbersome and difficult to overcome.

    Mike Kurta


---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/a3/7b/8b/ca/attachment.htm

---------------------- multipart/alternative attachment--