Terry, If you think about it, all new keybuttons are bushed from the bottom before they are installed. If you buy a set of new keybuttons, you don't expect to have to bush them yourself...;-] David Ilvedson, RPT Pacifica, CA 94044 ----- Original message ---------------------------------------- From: Farrell <mfarrel2 at tampabay.rr.com> To: "Pianotech List" <pianotech at ptg.org> Received: 7/17/2006 3:24:31 AM Subject: Re: Key Bushing Method, was: Key flexing >My key bushing experience is limited to rebushing old keys with the original >key buttons using the Spurlock method. Unless I'm really too-pid, the only >way one is going to bush the center rail mortises on that type of key setup >is from the top. Now I realize you used new buttons and that is likely the >difference. Did you bush them before button installation? Did you bush from >the bottom? If so, why? What would be the advantage? >Don't you do anything the "proper way"? You know, the way the original >masters did it? ;-) >Terry Farrell >----- Original Message ----- >From: "Ron Nossaman" >> The difference that comes immediately to mind is the bushing method. With >> two layers, the buttons can be bushed from the bottom. With one double >> thick button/plate, the bushing would have to be done from the top.
This PTG archive page provided courtesy of Moy Piano Service, LLC