Hi Ron. I did call Schaff and discussed the problem with Cal. They do not have the damper rod hook or I would not have asked for advice from the list. Thanks anyway. Regards, Gordon ----- Original Message ----- From: "Ron Nossaman" <rnossaman at cox.net> To: "Dave Davis" <dave at davispiano.com>; "Pianotech List" <pianotech at ptg.org> Sent: Wednesday, July 26, 2006 4:38 PM Subject: Re: Kimball Console-broken damper rod hook > > >> Try Schaff catalog page 107, No. 545 upper right column. Drive it in and >> bend it at the proper spot. A possible "field" repair is to use a nail >> and JB Weld it into place. >> Dave Davis, RPT > > > I've always wondered why people dink around with nails instead of just > buying a hundred of these things for about $4, splitting the order with > three other techs, and everyone will have a lifetime supply. I've probably > replaced a dozen or so in 30 years, and only found one instance where the > thing wouldn't work because it was shorter than the original. > > They make pretty good tooling locater pins too (even rivets), if you're > one of those (us) depraved souls who builds jigs and such. > > Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC