Stupid newbee!!! Stupid! Stupid!

[Farrell]

Stupid newbee!!! Stupid! Stupid!Someone mentioned setting the plug in with epoxy, so it bears pointing out that the tight fit suggested below would be for a glue joint. If you are using epoxy (like West System - I usually use it unthickened), you want to make the hole slightly larger than the plug.

Terry Farrell
  ----- Original Message ----- 

  >Drill out  31/32" hole to insert a Ready Made Plug from Pin Block Material


  I'd make that a 31/64" hole for the 32/64 (1/2") plug,
  metric would be so much easier.
Regards,Jon Page
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060521/e226685b/attachment.html