In a message dated 8/15/08 11:21:42 AM, nelsong at intune88.com writes: > Hello list, > I have been trying to modify three legs for new casters. It required that I > cut the legs short by 1.2 inch to maintain hight(done). In addition it > requires that I enlarge the existing .86 inch hole to 2 1/8 inch at .25 inch > deep. > In addition the existing .86 hole needs to be deeper by 1.5+ inch but it is > oversize by about .085 inch. > I have tried using my drill press and a forstner bit for the large shallow > hole but could find no way to secure the leg enought to get it started. > > Gene; Try plugging the hole flush with the old surface....then you will be able to hand drill appropiate sized holes without bit wandering....worked for me. Jim Bryant (FL) ************** Looking for a car that's sporty, fun and fits in your budget? Read reviews on AOL Autos. (http://autos.aol.com/cars-Volkswagen-Jetta-2009/expert-review?ncid=aolaut00030000000007 ) -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080815/1826a6aa/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC