Fenton Murray wrote: > More dittos Ron. I've long had the zact same drill press and so set it > up in similar fashion after meeting you and seeing your set up in KC a > few years back. > I cut lots of plugs ( 3 blocks worth ) with a cheap Chinese cutter that > I've yet needed to replace or sharpen. The secret seems to be to cut the > plugs near the edge of your stock so the cutter stays cools and throws > off the chips out the side. > See photo. > Fenton Hi Fenton. I've done them just like that, on the edge to minimize waste and heat buildup. The plugs I cut were Delignit, and generated quite a bit of heat at that. The composite is somewhat less dense overall, so it may not be a problem. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC