Hello Marco, Does Jahn have a catalog? Are these jigs available in the U.S.? Thanks, Gene ----- Original Message ----- From: "piano workshop" <info at pianoworkshopny.com> To: <pianotech at ptg.org> Sent: Saturday, May 02, 2009 10:01 AM Subject: Re: [pianotech] Renner hammer boring jig > This is the right boring machine ever...for my opinion. > It's expensive but do is job accurately. > These machine its Made in Italy but sold by Jahn - Germany. > I work with it more than 10 years without any problem. > Easy to set easy to use. > > Marco De Lellis > Piano Workshop Inc. > PTG - Registered Piano Technician > 21-05 31st. Avenue > Astoria New York, 11106 > USA > tel. 001 212 575 4949 > tel. 001 718 956 3110 > www.pianoworkshopny.com > info at pianoworkshopny.com > > > -----Original Message----- > From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On > Behalf > Of Mark Dierauf > Sent: Saturday, May 02, 2009 9:32 AM > To: Pianotech > Subject: [pianotech] Renner hammer boring jig > > Does anybody know if this jig will bore vertical hammers as well as > grands? I'm particularly wondering if it is capable of boring the > extreme rake angle found on the old S&S uprights. Thanks, > > - Mark > > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC