[pianotech] Renner hammer boring jig

[piano workshop]

Nobody sell this machine here in USA.
You can contact jahn 
Jahn

Manufacturers of Piano Parts 
Alfred Jahn, D-96271 Grub am Forst, Germany 
95 60/80 34 
Fax: 95 60/17 34 
I can do better in this monday

Or FTP in Italy at 011 39 0444 288725

If you have a problem contact me

Marco De Lellis
Piano Workshop Inc.
PTG - Registered Piano Technician
21-05 31st. Avenue
Astoria New York, 11106
USA
tel. 001 212 575 4949
tel. 001 718 956 3110
www.pianoworkshopny.com
info at pianoworkshopny.com
 

-----Original Message-----
From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf
Of Gene Nelson
Sent: Saturday, May 02, 2009 2:49 PM
To: pianotech at ptg.org
Subject: Re: [pianotech] Renner hammer boring jig

Hello Marco,
Does Jahn have a catalog? Are these jigs available in the U.S.?
Thanks,
Gene
----- Original Message ----- 
From: "piano workshop" <info at pianoworkshopny.com>
To: <pianotech at ptg.org>
Sent: Saturday, May 02, 2009 10:01 AM
Subject: Re: [pianotech] Renner hammer boring jig


> This is the right boring machine ever...for my opinion.
> It's expensive but do is job accurately.
> These machine its Made in Italy but sold by Jahn - Germany.
> I work with it more than 10 years without any problem.
> Easy to set easy to use.
>
> Marco De Lellis
> Piano Workshop Inc.
> PTG - Registered Piano Technician
> 21-05 31st. Avenue
> Astoria New York, 11106
> USA
> tel. 001 212 575 4949
> tel. 001 718 956 3110
> www.pianoworkshopny.com
> info at pianoworkshopny.com
>
>
> -----Original Message-----
> From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On 
> Behalf
> Of Mark Dierauf
> Sent: Saturday, May 02, 2009 9:32 AM
> To: Pianotech
> Subject: [pianotech] Renner hammer boring jig
>
> Does anybody know if this jig will bore vertical hammers as well as
> grands? I'm particularly wondering if it is capable of boring the
> extreme rake angle found on the old S&S uprights. Thanks,
>
> - Mark
>
>
>
>
>