I want the regulation specifications for this piano that is equipped with a modern action. What is stated in my 1991 Piano Action Handbook for Bluthners does not apply and I find nothing on this list. The key height on that piano is 71 mm ,far from the 62-65 mm stated for the generic Renner we find in the same Handbook making me think there must be something else available. Can somebody help me? Thank you Allan Sutton www.pianotechniquemontreal.com -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of piano workshop Sent: 2 mai 2009 15:33 To: pianotech at ptg.org Subject: Re: [pianotech] Renner hammer boring jig Nobody sell this machine here in USA. You can contact jahn Jahn Manufacturers of Piano Parts Alfred Jahn, D-96271 Grub am Forst, Germany 95 60/80 34 Fax: 95 60/17 34 I can do better in this monday Or FTP in Italy at 011 39 0444 288725 If you have a problem contact me Marco De Lellis Piano Workshop Inc. PTG - Registered Piano Technician 21-05 31st. Avenue Astoria New York, 11106 USA tel. 001 212 575 4949 tel. 001 718 956 3110 www.pianoworkshopny.com info at pianoworkshopny.com -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Gene Nelson Sent: Saturday, May 02, 2009 2:49 PM To: pianotech at ptg.org Subject: Re: [pianotech] Renner hammer boring jig Hello Marco, Does Jahn have a catalog? Are these jigs available in the U.S.? Thanks, Gene ----- Original Message ----- From: "piano workshop" <info at pianoworkshopny.com> To: <pianotech at ptg.org> Sent: Saturday, May 02, 2009 10:01 AM Subject: Re: [pianotech] Renner hammer boring jig > This is the right boring machine ever...for my opinion. > It's expensive but do is job accurately. > These machine its Made in Italy but sold by Jahn - Germany. > I work with it more than 10 years without any problem. > Easy to set easy to use. > > Marco De Lellis > Piano Workshop Inc. > PTG - Registered Piano Technician > 21-05 31st. Avenue > Astoria New York, 11106 > USA > tel. 001 212 575 4949 > tel. 001 718 956 3110 > www.pianoworkshopny.com > info at pianoworkshopny.com > > > -----Original Message----- > From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On > Behalf > Of Mark Dierauf > Sent: Saturday, May 02, 2009 9:32 AM > To: Pianotech > Subject: [pianotech] Renner hammer boring jig > > Does anybody know if this jig will bore vertical hammers as well as > grands? I'm particularly wondering if it is capable of boring the > extreme rake angle found on the old S&S uprights. Thanks, > > - Mark > > > > > No virus found in this incoming message. Checked by AVG - www.avg.com Version: 8.0.238 / Virus Database: 270.12.4/2078 - Release Date: 05/01/09 17:52:00
This PTG archive page provided courtesy of Moy Piano Service, LLC