Fast. It's faster! Cooler too, also easier on your drill probably. You should deglaze the hole when you're done anyway. David Love www.davidlovepianos.com -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Rob McCall Sent: Monday, March 07, 2011 9:45 PM To: pianotech at ptg.org Subject: [pianotech] Pin removal speed Greetings, What's the consensus on the speed at which to remove tuning pins from an otherwise good pinblock? I've read to go slow as to not heat up or burnish the hole, and I've read someone on here recently who recommended the exact opposite, namely to go fast so as to not build up excessive heat. So which do you use? Why? Are your results consistent? Thanks, Rob McCall McCall Piano Service, LLC www.mccallpiano.com Murrieta, CA 951-698-1875
This PTG archive page provided courtesy of Moy Piano Service, LLC