Ed, Thank you for the reply. I have a DeWalt 10amp 1/2" drill that'll go from 0-1200 rpm in a heartbeat. Fast would obviously be quicker. I just want to make sure there aren't any unforeseen pitfalls. I figure my drill will pull each pin out in under 2 seconds. That's my preferred method. Regards, Rob On Mar 08, 2011, at 04:43 , Ed Foote wrote: > There ain't gonna be no consensus. We all do it differently. > I have, for decades, removed the pins as fast as a 1/2" Milwaukee drill will turn them out. Never found any evidence of damage. The pins are hot enough to hurt > if you pick them up, but I have never seen scorching or other ills. (and I don't like to lean over in that posture longer > than I have to). > Regards, > Ed -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20110308/954e9808/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC