Rob sez: I have a DeWalt 10amp 1/2" drill that'll go from 0-1200 rpm in a heartbeat. Fast would obviously be quicker. I just want to make sure there aren't any unforeseen pitfalls. I figure my drill will pull each pin out in under 2 seconds. That's my preferred method.>> I have always tried to figure just how much trigger I needed to apply to get the pin to stop spinning just as it came out of the hole. With over 200 pins to remove, I don't want to waste 3 seconds per pin letting the drill stop, and I don't like to drop the spinning socket over the next pin, so, I want to let the pin almost stop the drill as it comes out the last thread or so. I always get it just right about twenty holes from the finish line.. Regards, Ed Foote RPT -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20110308/d85bf435/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC