[pianotech] is there a tool for this

[Joe Goss]

Hi. Make a strap iron spanner.
No need to make it fancy as you will seldom use it. 

Joe Goss BSMusEd MMusEd RPT
imatunr at srvinet.com
www.mothergoosetools.com
----- Original Message ----- 
From: "Gene Nelson" <nelsong at intune88.com>
To: <pianotech at ptg.org>
Sent: Wednesday, June 27, 2012 9:51 PM
Subject: [pianotech] is there a tool for this


> Any ideas how to unscrew this?
> Is there a tool made just for this?
> Any home made tool designs someone might want to share?
> Two #10 WNG bridge pins fit into each recess but will not budge it when I
> turned them with a big crescent wrench.
> Possibly some square steel rod that fit a bit better would be helpful. 
> Thanks,
> Gene
>