And it's non-marring should you happen to exceed your depth stop. ;-] Not that I ever have of course.............I had this friend, see.......... William R. Monroe On Fri, Nov 2, 2012 at 1:23 PM, Chuck Behm <behmpiano at gmail.com> wrote: > >Paul > > Before you remove the pins, tape a hammer shank against the side of your > tuning pin punch, so that the shank touches the plate. > > Wim< > > The trouble with a rigid "depth gauge" such as a hammer shank is that each > time you tap the pin down until the shank makes contact with the plate, it > will be pushed up a bit, until there is a discernible difference. > > I've used the same method as Bill Monroe for years, a sliver of rubber > wedge that I tape (with electrical tape) to the side of the punch. Works > great. Chuck Behm > -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20121102/2b69b69e/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC