---------------------- multipart/alternative attachment Wim and Vince, My question would be, what happens to the spacing of the rep to the=20 hammer shank/knuckle after these acrobatics you mention? I certainly shim the whip flange in order to space the lever to the=20 hammer flange, but I prefer to keep the top of the rep lever as=20 horizontal as much as possible, and not tilt the lever off of 90=20 degrees if I can help it. But what I'm really getting at is this: I notice quite a few of the=20 capstans I've removed were slightly off center of the keys anyway, and=20= not always in the right direction (making the capstan spacing=20 noticeably off). It just seems to make sense to me to take advantage of=20= the opportunity (while drilling new capstan holes) to see where the=20 whip heels are when all the action parts are properly spaced to the=20 strings (particularly in the bass and tenor, where the strings can't be=20= moved) and drill capstans off center purposely in the right direction. Probably even just some form of eyeballing the relationship of the whip=20= heels to the keys could be used to mark where to drill the capstan=20 holes. I wondered though if anyone has thought about this and perhaps=20 come up with a real accurate way to do it. I also wonder if there is any reason why slightly off-center capstans=20 could be a bad idea, in terms of geometry or wear. Perhaps more wear on=20= one side of the keybushings? I imagine that would be subtle if=20 noticeable at all. Any comments will be appreciated. Cheers, Allen Wright Northern Kentucky University On Wednesday, August 4, 2004, at 03:28 PM, Wimblees@aol.com wrote: > In a message dated 8/4/04 11:15:10 AM Central Daylight Time,=20 > awright440@cinci.rr.com writes: > > I > noticed before removing the capstans that quite a few of them aren't > centered perfectly to the whip heels, some being quite noticeably off > to one side or the other. The rep levers are spaced to the hammer > shanks accurately (with the hammers spaced to the strings). > > > Alan > =A0 > You can try to center the cushions=A0over the capstans by tilting the=20= > wips.=A0You might need to paper the flange to do that, just like you=20= > paper one corner of a hammer flange to move the hammer to the right or=20= > lift. (not the same as traveling). > =A0 > The other way to center the capstan under the wippen is to move the=20 > front of the key. I just did this on an older D. There=A0were quite a=20= > few=A0capstans that were not=A0center under the wippen cushions. So = after=20 > I tilted the wips as much as I could, I moved the front of the key=20 > slightly, and moving some of the keys around them to make sure=20 > the=A0keys were still evenly spaced. Also, make sure the keys are = level.=20 > That can also effect the centering of the capstan. > =A0 > Wim > Willem Blees, RPT > Piano tuner/technician > School of Music > University of Alabama ---------------------- multipart/alternative attachment A non-text attachment was scrubbed... Name: not available Type: text/enriched Size: 2898 bytes Desc: not available Url : https://www.moypiano.com/ptg/caut.php/attachments/b6/9b/ce/12/attachment.bin ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC