[CAUT] Bridge pin removal

[Greg Newell]

Ron,
         you know your getting too tired when the "smack you upside 
the head obvious just isn't obvious anymore. Off to bed. Thanks for the help.

Greg



At 12:09 AM 12/14/2006, Ron Nossaman wrote:

>>Ron,
>>         My question is; have you welded the dent puller slide 
>> hammer to the threaded screw of the vise grip or what? The dent 
>> puller I found that was close to the right size was still too 
>> large a diameter rod to thread down to the vise grip size. Maybe 
>> you use more robust dies than I do. :-)
>>all the best,
>>Greg Newell
>
>Hi Greg,
>I just chose a rod size that would fit the Vise-Grip. Interestingly 
>enough, the slide weight fit over it just like it did the bigger rod 
>that it was originally made for. Go figure... <G>  One end of the 
>rod screws into the Vise-Grip (with a wing nut to lock it), and the 
>other end has a double nut to act as a stop for the slide. The 
>sloppy slide fit still hammers just fine.
>Ron N