I tuned a Kohler and Campbell upright yesterday. I had a time limit of how long I could stay, about 2 hrs and 15 minutes. So I set about to do the best I could the fastest I could. (I tend to be the pokey type tuner). It hadn't been tuned for several years, but the pins were tight and it seemed to be going well. Until: the lady of the house decided she was cold upstairs (piano is in lower level of a split) and she cranked the heat up. The warm air proceeds to blow all over the 3/4s tuned piano. By the time I got finished and started checking my work with my accutuner, it had already sunk flat again. I was almost out of time and couldn't go through the whole keyboard again so I tweaked the ones that I could and pronounced it "good enough". Not sure how I should feel about that and am looking for advice on when "enough is enough". The customer thought it sounded fine, but I left feeling as if I hadn't done my best. Waiting for input, Karen Johnson ptg associate Rochester, MN
This PTG archive page provided courtesy of Moy Piano Service, LLC