Thanks Roger, sizing... uh does that mean soaking? And what proportions? Kristinn At 11:20 3.9.2000 -0600, you wrote: >Hi Kristinn, > If the centre's look clean, no verdigris, and you have a >lot of sluggish centre's. >Try sizing the bushing's with alcohol and water, leave 24hrs to dry >naturally. It will save a lot of work and give consistent results. Drying >with a hair drier tends to over shrink the bushings. >Regrads Roger > > >At 05:06 PM 03/09/00 +0000, you wrote: > > > >Hey List > > > >I´m just about to take a spinet action and check out all the centers. It´s > >had some sticking problems > >I´ll start by lubing, figured I´d let it wait a little. Then check each > >pin, and do some reaming and replacement. > > > >I was just wandering whether there´s anything else interesting I could do > >e.g. letting it sit out in the sun, put a blow dryer on it etc. :) > > > >No honestly. Do you have any suggestions? (scientifically proven methods > >or not) <G> > > > >Just taking advantage of ALL knowledge out there, > > > >Kristinn Leifsson > >Reykjavík, Iceland > > >Roger Jolly >Saskatoon, Canada. >306-665-0213 >Fax 652-0505
This PTG archive page provided courtesy of Moy Piano Service, LLC