Hi folks... Here is another way that works good: Take a center-rail pin and pund one end flat. As you do this it will expand to the width you desire. Make a small handle for it out of piece of dowel. Insert this tool in the top of the key parallel to the bushing. Then rotate it one-half turn and push it thru. This will widen the bottom hole but not lenghtn it.....thus avoiding "pully" keys. Dick RPT MT ----- Original Message ----- From: Lance Lafargue <lancelafargue@bellsouth.net> To: <pianotech@ptg.org> Sent: Thursday, January 04, 2001 10:53 AM Subject: RE: RE: "pulley" keys
This PTG archive page provided courtesy of Moy Piano Service, LLC