pinblock hole alignment

[Jon Page]

---------------------- multipart/alternative attachment
At 10:22 AM 05/09/2001 -0400, you wrote:
>Misaligned pinblock hole:
>I just finished drilling out a pinblock (Bolduc) for a grand.  One
>hole (in the bass) ended up misaligned so that the edge of the hole
>is slightly under the plate (about 1/128th inch) on the agraffe side.
>I see two options:  1)   2) file the bottom edge of
>the plate hole to prevent the pin contacting the plate.  (The holes
>were drilled at a 5 degree angle.)  I will be using bushings.
>Any advice?
>Thanks,
>Larry Toto
>

plug and redrill

---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/f1/a0/bb/f8/attachment.htm

---------------------- multipart/alternative attachment--