Dear Lists, Not too terribly recently I read of the benefits of 3M's fre-cut gold sand paper. I recently bought some from Jeff Jewitt who told me to use it between coats of Oxford Premium spray lacquer. I found that it began to remove some material and that material then balled up and began to cut grooves in my new soundboard finish! YIKES! I waited at least 24 hrs before sanding between coats. Should i have waited longer? Is there a better way to use this highly acclaimed product? Are there different uses for this paper rather than between coats? I assume that it is used dry as it is a paper backing. Is that right? All was saved with a scotchbrite pad and some careful rubbing. I applied the decal and am now ready at my next opportunity to spray over it. So far it looks great! Greg -- Greg Newell Greg's Piano Forté 12970 Harlon Ave. Lakewood, Ohio 44107 216-226-3791 mailto:gnewell@ameritech.net
This PTG archive page provided courtesy of Moy Piano Service, LLC