3M sandpaper

[Ron Nossaman]

> Most of it looks real good, but some areas (maybe
>where I rubbed a little harder) have a bit of a milky appearance. It is
>definately not the clear finish that is milky - it was very clear before
>sanding - but rather a bit of a milky haze apparently from the final rub-out
>with the Scotch-Bright pad.

Hi Terry,
Finishing isn't my thing, but this sounds familiar. Do you use a wool wax
or other lubricant with the final rubdown? If the clear coat wasn't like
that, I'd rub down again with wool wax (very watery). I think it may just
be refraction from surface scratches, which the wax fills.


Ron N