What I meant was that I've seen the aeolian hammers let go with or without staples. I feel the staples have little holding power if the glue joint fails. Hammer felt that is wired through the molding and twisted I suspect will never let go .--- Tom D.-- Original Message ----- From: <JIMRPT@AOL.COM> To: <pianotech@ptg.org> Sent: Thursday, May 24, 2001 9:00 AM Subject: Re: Re: Hammer Staples > > In a message dated 5/24/2001 11:04:13 AM, Richard B. wrote: > > <<"Hi Tom... am I right in reading that you response says you observe no real > connection between hammers looseing their grip on the molding and the staple > being there or not ??">> > > Richard; > There needs to be some differetiation made between "staples" and "staples":-) > Hammer staples come in various forms: > 1.) true staples where the legs remain straight when driven in. > 2.) what I will call 'clinched' staples where the staple penetrates from one > side of the hammer and the legs are 'clinched outward, forming a 'clamp of > sorts. > 3.) "T" staples which can take either of the above two forms. > 4.) Tied wire/staples, ala S&S. > > Of the four above types, I am sure there are more, only No. 2 and No. 4 > offer any significant 'holding' power for keeping felt secured to the hammer > moulding. The other two are window dressing...mostly. :-) > Jim Bryant (FL)
This PTG archive page provided courtesy of Moy Piano Service, LLC