Hi Kevin and Charles know about it. The newer Walters have changed to a split lifter rail and not a double rail system found on the ones you have serviced. Richard Raskob RPT -----Original Message----- From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org]On Behalf Of David M. Porritt Sent: Saturday, February 23, 2002 1:54 PM To: pianotech@ptg.org Subject: Re: Puzzler: damper squeek David: My squeak was also a Walter. Maybe we should tell Charles about this! dave *********** REPLY SEPARATOR *********** On 2/23/02 at 3:10 PM David Renaud wrote: >David M. Porritt wrote: > had one of these last week and I still need to get >> back to fix it. >> The damper lifter rod is scraping across the tops of >> the spoons. Is that what you found? > >Bingo > >There is very very little clearence bettween the >spoons >and the lift rod. When the rod bushings were new It >may >have been ok but with a normal 10 years wear on them >they have a little bit of play, and the rail scrapes >the tops of the spoons. > >Had not seen this one before. >Perhaps I should I move the rail up 1mm, >plug and redrill for the rod hinges, then rebush, >there a little room to do this > >The piano is a Walters upright, havn't seen this one >in Ottawa before. Nice instrument. Great sounding >upright. > > Cheers > Dave Renaud > RPT > > > > > > > > >_____________________________________________________________________ _ >Web-hosting solutions for home and business! http://website.yahoo.ca _____________________________ David M. Porritt dporritt@mail.smu.edu Meadows School of the Arts Southern Methodist University Dallas, TX 75275 _____________________________
This PTG archive page provided courtesy of Moy Piano Service, LLC