---------------------- multipart/alternative attachment In a message dated 10/11/2002 9:27:29 PM Pacific Daylight Time,=20 RNossaman@cox.net writes: > Ron=20 How are you milling maple that thin? Dale >=20 > Dale, > The problem with notching Delignit, and likely Falconwood as well though I= =20 > haven't tried it, is the 90=B0 cross ply. Laminating 1.5-2mm maple at unde= r=20 > 10=B0 angles gets you enough cross plying for strength, but it's still clo= se=20 > enough to parallel to hand notch if you don't happen to have built a power= =20 > notcher just yet. Try it. It's terrific stuff. >=20 > Ron N >=20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/0c/b5/fc/a5/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC