It also depends upon the size of the pianist's fingers, so there is no one right" height. Thump --- antares <antares@euronet.nl> wrote: > Well I am not a manufacturer but when I think about > it it should be logical. > A higher sharp is uncomfortable and a lower sharp > too. > Besides, a lower sharp would make your fingers touch > the whites, just like > when there is too little paper punching under the > sharp. > I remember playing on several pianofortes and > harpsichords which had the > weirdest (in comparison with modern keyboards) > whites and sharps. > Some felt ok but others were strangely narrow or > low. > > So I suppose 12 mm for sharps is an accepted and > comfortable height and high > enough to make a proper key dip without touching the > white keys. > > > > friendly greetings > from > > Antares, > > Amsterdam, Holland > > "where music is, no harm can be" > > visit my website at : > http://www.concertpianoservice.nl/ > > > > From: Avery Todd <avery@ev1.net> > > Reply-To: Pianotech <pianotech@ptg.org> > > Date: Fri, 18 Oct 2002 15:23:28 -0500 > > To: Pianotech <pianotech@ptg.org> > > Subject: Re: key dip, dip in..... > > > > Andre, > > > > Why? > > > >> Most manufacturers use 12 mm for the sharps. > >> > >> > >> friendly greetings > >> from > >> > >> Antares, > >> > >> Amsterdam, Holland > >> > >> "where music is, no harm can be" > >> > >> visit my website at : > http://www.concertpianoservice.nl/ > >> > >> _______________________________________________ > >> pianotech list info: > https://www.moypiano.com/resources/#archives > > > > > > _______________________________________________ > > pianotech list info: > https://www.moypiano.com/resources/#archives > > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives __________________________________________________ Do you Yahoo!? Y! Web Hosting - Let the expert host your web site http://webhosting.yahoo.com/
This PTG archive page provided courtesy of Moy Piano Service, LLC