At 10:14 PM 10/22/2002 -0400, you wrote: ><snip> >But I'm curious. Has anybody tried to slim down a flange leg(?), say a >specified and uniform 20 mils. Certainly a milling machine, but few of us >have that. How about a table saw (sliding fence jig)? A router table (once >again a sliding jig)? An over-arm router would nice. A 1" saw blade >mounted in a Dremel miniature milling machine? How about a band saw with a fence setup. Regards, Jon Page, piano technician Harwich Port, Cape Cod, Mass. mailto:jonpage@attbi.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC