---------------------- multipart/alternative attachment In a message dated 10/22/02 9:41:12 PM Central Daylight Time, mfarrel2@tampabay.rr.com writes: > When drilling tuning pin holes in new block in a full plate with no plate > bushings, how best to center pin? If you are either drilling the block in the piano, or outside the piano, drill a dimple first with a drill bit the same size as the tuning pin hole. This will then allow the bit for tuning pin to find the center of the hole. By the time the pin "bends" with tension, it will not touch the front, nor the back. Wim ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/5e/b6/2d/77/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC