I would try several tests. First I would ream some test holes for the correct size. Then mike your new pins and drive a few different sizes into some of the existing holes and check the torques. Then try your epoxy thing and dirve in some more pins to see how it feals. If you like it then there you are. In my opinion the thought of replacing the block will haunt me forever after doing all of the work involved with a new board and everything else. -----Original Message----- From: Danny Boddin [mailto:danny.boddin@pandora.be] Sent: Friday, January 03, 2003 14:08 To: Pianotech Subject: Broadwoodgrand°1894 This Broadwood has oblong threaded tuningpins which go into the plate before they catch the pinblock. We intend to replace them with the same size normal tuningpins which first will get a thread of the same dimension. Nicer looking and easier tuning. Do you think this will work? I mean, will this piano hold his tuning afterwards? The pinblock itself is in good condition and we prefer not to replace it: the plate seems to be glued on it, probably difficult to remove or not? Meaby we can put some epoxy in the pinblockholes for better fix of the new pins? This 2 meter grand will get a new ciresa soundboard. Any idea what kind of strings and best sounding scale we can use for restringing? I'm scared to use the 'pure sound' since even with the right calculated scaling up to the specifications from Juan Mas Cabré in some grands we restrung some strings broke after a while and even one year later. Thanks, Danny Boddin Ternat, Belgium
This PTG archive page provided courtesy of Moy Piano Service, LLC