---------------------- multipart/alternative attachment Wally, Aluminium is structurally fine to use for the plate, provided that its strut section sizes are increased slightly to allow for the lower yield point of Aluminium compared to cast iron. However, the big problem with using it has to do with tuning stability. Aluminium has a much higher thermal expansion rate than does SAE 1085 piano wire (by a factor of around 3 from memory). So the tuning stability will be, all other factors being equal, inferior. Ron Overs. >. . . I didn't notice any particular problems as a result of this >being an aluminum plate, so wondered why the practice didn't >continue. Anyone informed as to the history of the aluminum piano >plate? > > > > >Wallace T. Scherer, Piano Technician, Music Educator >Piano Tuning & Repairs, Piano Lessons, Edwards String Covers >P.O. Box 4121, Lantana, Florida, 33465 >Phone: 561-432-4121 >Web page: http://www.angelfire.com/biz6/afinetune > > > >Do you Yahoo!? >Friends. Fun. <http://messenger.yahoo.com/>Try the all-new Yahoo! Messenger -- OVERS PIANOS - SYDNEY Grand Piano Manufacturers _______________________ Web http://overspianos.com.au mailto:info@overspianos.com.au _______________________ ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/e6/16/c3/54/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC