This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment BTW Avery, The tool looks almost the same except for the hook at the tip. It is bent the same so that the tool remains centered above the capstan = while turning the capstan out. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: Avery Todd=20 To: Pianotech=20 Sent: Monday, August 01, 2005 3:14 PM Subject: Re: capstan remover update Hey, Joe. Well, where's the picture????? :-)=20 Avery=20 At 12:55 PM 8/1/05, you wrote: Hi Folks , Gotta give the other Joe G a thanks for the insight to make the = better design on my original try. The second attempt produced a 1/4" hex tool but the working end is = minus the hook that I thought might be needed to hold the tool on the = capstan. And is now much stronger.=20 Total length is about 2 1/2" with the tip 7/16" X .103" Leaving = clearance to be used with the keys still on the rail. =20 The bit will work in a small cordless electric screw driver or = larger unit if you want the power or a standard 1/4" hex drive handle = for manual removal of a few. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com -----=20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/39/76/e0/52/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC