This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment I have scraped it off with a razor or knife and then dressed the finish with a little 4/0 steel wool. You could even use some 600 sandpaper first and then the steel wool. Try an inconspicuous area first to see how it is going to look on the finish. But if you can hardly see it now probably hitting a couple of times with the steel wool will make it disappear. Dean Dean May cell 812.239.3359 PianoRebuilders.com 812.235.5272 Terre Haute IN 47802 -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of Piannaman@aol.com Sent: Thursday, July 28, 2005 9:29 PM To: pianotech@ptg.org Subject: Howdya get CA off of polyester??? Hi all, I just finished tuning a satin walnut polyester piano that has a few loose pins. It's a couple of years old, and still under warranty, but I figured I try to CA a couple of pins anyway. Just to prove that performing that operation requires care and patience, I spilled a very small amount on the keyslip....:-([( At least it isn't laquer. I got most of it off before it had time to set, but as we all know, the stuff dries durned fast! So there are a couple of very small marks on the front. The finish doesn't appear to be damaged at all, and it's hardly visible, but I can see it. I'd like to do right by the customer and get it off if possible, but I didn't want to apply chemicals that might take the finish off in conjunction with the glue... If any of you have an idea about how to remove this stuff, please let me know! It's always on the fourth tuning of the day... Thanks in advance! Dave Stahl ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/46/81/99/61/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC