Hi Mark, Looks more like three thick laminations of Pianoteck Maple Multilam and two thicker pieces of solid maple. Doesn't really look like a Delignit cap to me. I'm not quite sure what going on there...... Below is a picture of a Pianotech multilam capped with a thin piece of Delignit pinblock material. Below is a quarter-sawn hard-maple pinblock capped with a piece of Delignit bridge-cap material. The quarter-sawn nature of this block is similar to the original Bolduc design. Interesting. I wonder what is the story with that Bolduc stuff...... Terry Farrell ----- Original Message ----- > Anyone seen the new Bolduc "hybrid" pinblock? > > (runs on bio-diesel?) > >> From the photo, looks similar in some ways to what Ron N. and >> others are > trying to acheive, by laminating a top layer of Delignit (or similar) > onto > standard pinblock stock. > > Mark Cramer, > Brandon University -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070425/4a030f24/attachment-0001.html -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 45614 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20070425/4a030f24/attachment-0002.jpe -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 39134 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20070425/4a030f24/attachment-0003.jpe
This PTG archive page provided courtesy of Moy Piano Service, LLC