It's been a month since I saw the piano, but I do remember that only the damper pedal had the pin through the lift rod. I believe there is a guide rail, but I'll be sure to keep that in mind when I take care of it. Thanks Loren ----- Original Message ----- From: Susan Kline To: pianotech at ptg.org Sent: Friday, January 07, 2011 10:33 PM Subject: Re: [pianotech] Baldwin Pedal with squeaky rubber grommet On 1/7/2011 4:31 AM, Tom Driscoll wrote: I would consider losing the pin setup and creating a leather pocket in the pedal and lubing the inside with VJ. I suspect that this pin was introduced to make up for the lack of a guide rail for the pedal rods. I'd suggest thinking twice before removing it permanently. I once heard of a Baldwin pedal rod jumping right out of the socket in concert and clattering onto the stage. If you want to change the setup, building and installing a guide rail high up (in the usual place) might be the way to go. Susan Kline -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20110110/d07a850f/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC