---------------------- multipart/alternative attachment Hi Patrick - I'll intersperse my comments. Today I'll use white, no that won't work, I'll use maroon. At 10:34 AM 6/26/2005 -0400, you wrote: >On Jun 26, 2005, at 2:15 AM, David Skolnik wrote: > >>Patrick - >> >>I would echo Joel's reply, at least the part about rolling the pin >>between files, as I haven't used the Pianotek reamers. > >I have done that in the past, and a roughened center pin (which is >essentially what the Mannino broaches are, though done more nicely than I >usually achieve by rolling center pins between files) certainly works very >well for felt bushings. It's just that I imagine a microscopic view of the >results to the teflon bushing, and doubt that the results equal or exceed >factory specs for the bearing surfaces. Well Pat, I can only say you must have quite a vivid imagination. I too would enjoy seeing a microscopic view of a teflon bushing. Frankly, I would enjoy seeing microscopic views of just about anything. On the other hand, I suspect the microscopic condition is not as critical to the functioning of teflon bushings as you might wish. As for "factory specs"...which factory would that be? An imagination AND a sense of humor! Anyway, it would be equally interesting to be able to observe the cutting process of a reamer, especially the effects of a somewhat dulled reamer. I suppose you could further refine the abraded surface of the center pin using some files made from various grit sandpaper. >ds >>Drill bits won't work, at least in part because they are not accurate enough, >pd >I would expect to mic any bits that I used Yes, but if you do locate bits that are indeed accurate to .0005", how much less are you going to pay for them? I don't know. But even aside from the next point, below, remember you are "drilling" into a plastic material wherein there will be some degree of deformation. The same pressure that is necessary for the cutting edge to remove material will, to some degree, be deforming the material. You would not be able to achieve the same degree of tolerance as you would expect working with, say, metal. (ds) >>and, I suspect, because their main cutting edge is at the bottom, not the >>sides. >(pd) >Huh? Certainly not the way I envisioned drill bits functioning -- do >others agree with your evaluation of the way drill bits cut? I'd be curious to know as well. I have some books on subject which I will try to peruse. Stay cool - David Skolnik "I could be wrong" ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/4e/7b/a2/97/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC