This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Ohoh. Is this the one with the wood rail with the stickers comming up = through it? If it is you need 4 or 5 damper heads drilled out to, I think it is 1/8 = inch. You will capture the wire end of the sticker at the end of each section. This one is easy but still look for the brace. It may be a rod. Rough setting of lost motion can be done by adjusting the hight of the = sticker rail. You will want to purchase a 12" long thin 1/8" screwdriver. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: richard.ucci@att.net=20 To: pianotech@ptg.org=20 Sent: Wednesday, August 03, 2005 7:06 PM Subject: howard spinet Hi Guys, Came across a baldwin howard spinet with jack flanges that are comming = unglued. I want to pull the action, but it was designed in a way I have = yet to see. Bolted to the plate-no struts, and these long flat metal pieces that = are screwed into the wooden platform under the action. Anything I should be aware of other than the usual stuff? Also , will = the pianotek sticker holder work on this model? Thanks, RU/UP ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/aa/36/64/40/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC