This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Barbara R. asked: "Are there any secrets besides just plain old = rebushing? For example, do =3D you shrink the bushings after you've put them in?" Barabara, I usually get all the flanges prepped then "gang" bush them. i.e. thread = several on a strip of bushing cloth. Once the hide glue has set, just = slice them apart. Another trick, that I personally haven't used, but is = touted by the Euros, is to use the long center pin "rods" in the same = process. If I am doing single bushings, I always insert a pin into the = bushing for sizing. This seems to give me more consistancy. I should = think shink/sizing would be a good idea. I don't envy your predicament! = (if it were me, I'd give a HUGE Bitch in S&S direction.) Hmmm? I've got = an A 3 coming up... I hope they've gotten their flanges better by then! Best Regards, Joe Garrett, R.P.T. Captain, Tool Police Squares R I ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/48/ba/87/57/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC